Timer

This countdown timer is perfect for epoxy doming. You set the desired time in minutes and seconds and press start, when the time is up it can be stopped by pressing stop or it will beep for 30 seconds and reset itself. One of the unique features of this timer is that it when done it will put the same time back on the time. For example, if you put 15 minutes on the timer and then start, at the end of the 20 minutes if you press stop or let the it beep for 30 seconds the timer resets to 20 minutes and is ready to go again, just press the start and it will start counting down 20 minutes again. Of course you can always reset and change the amount of time anytime you desire.

The timer has a 3 way stand on the back, it can be stuck on a metal surface with the magnet imbedded in the stand, the stand also has a built in clip that can be attached to a vertical surface or clipped onto a belt of pocket, next this clip has a wire holder that can hold the clip open and then it acts as an easel so it can stand upright on a table or desk.