Epoxy Resin Mixer

$8.50
Now in available in 3 different colors

The Mix Monster is 3D printed and we use a 1/8" stainless steel shaft, this means it won't rust and can be used either in a drill or Dremel or other rotary tools that use a 1/8" collet.

The mixer design (by me) to create a small vortex when mixing epoxy resin. This allows complete mixing in record time and with little to no air bubbles.

The mixer is 6" tall, the blades are approximately 1" diameter and 1" tall

To clean simply spin the mixer on high inside a discarded container or inside a trash can, this will dislodge 95% of the resin, then simply wipe with a paper towel and something like isopropyl alcohol, then it's ready to use again.

Please note that Dremel or drill are NOT included.
Primary color:
Now in available in 3 different colors

The Mix Monster is 3D printed and we use a 1/8" stainless steel shaft, this means it won't rust and can be used either in a drill or Dremel or other rotary tools that use a 1/8" collet.

The mixer design (by me) to create a small vortex when mixing epoxy resin. This allows complete mixing in record time and with little to no air bubbles.

The mixer is 6" tall, the blades are approximately 1" diameter and 1" tall

To clean simply spin the mixer on high inside a discarded container or inside a trash can, this will dislodge 95% of the resin, then simply wipe with a paper towel and something like isopropyl alcohol, then it's ready to use again.

Please note that Dremel or drill are NOT included.