Fiber Laser Drop In Guide Jigs 6pc Set no bolts required : Not for Deep Engraving

$14.50
sold out
These are simple drop in guides for your galvo or fiber lasers with holes that are 25mm on center (standard for most but not X-Tool F1 series). Simply drop these in place and put your item up against them (not for deep engraving because of heat).

The 4 straight pieces are 110mm long and 10mm wide, the L pieces are 60mm x 60mm
They are very low profile at only 5mm tall (when installed) the pins are 8mm long.

They have a half moon cutout on the bottom on one edge to aid in easy removal/ Be sure to lift straight up and not at an angle, doing so you risk breaking the pins off but they pull up really easy so it should not be an issue.

You will receive 4 straight pieces and 2 L shapes

These are 3D printed from high strength PLA plastic (plant based).
These are simple drop in guides for your galvo or fiber lasers with holes that are 25mm on center (standard for most but not X-Tool F1 series). Simply drop these in place and put your item up against them (not for deep engraving because of heat).

The 4 straight pieces are 110mm long and 10mm wide, the L pieces are 60mm x 60mm
They are very low profile at only 5mm tall (when installed) the pins are 8mm long.

They have a half moon cutout on the bottom on one edge to aid in easy removal/ Be sure to lift straight up and not at an angle, doing so you risk breaking the pins off but they pull up really easy so it should not be an issue.

You will receive 4 straight pieces and 2 L shapes

These are 3D printed from high strength PLA plastic (plant based).