Silhouette Cameo 3 Edge Guide (2pc.)

$8.50
This is a guide to help you insert your 12x12 cutting mat into the Silhouette Cameo 3 (may work for others but I don't have to test).

This is 3D printed from plant based PLA plastic and comes with 3D VHB (very high bond) tape on the bottom, simply clean the area it will stick to, peel off the backing (it's a little tricky as it's stuck on good but you can do it) align with current blue guide line edge and bottom and apply.

The piece is 20mm x 20mm and the guide is 10mm tall. You will receive 2 units (because we all make mistakes) but only install one and only install on the left side.

Be sure the edge is aligned even with the blue line and the bottom of the guide should be even with the blue line.

If you do need to remove, use isopropyl alcohol and dental floss under the unit to loosen the tape.
This is a guide to help you insert your 12x12 cutting mat into the Silhouette Cameo 3 (may work for others but I don't have to test).

This is 3D printed from plant based PLA plastic and comes with 3D VHB (very high bond) tape on the bottom, simply clean the area it will stick to, peel off the backing (it's a little tricky as it's stuck on good but you can do it) align with current blue guide line edge and bottom and apply.

The piece is 20mm x 20mm and the guide is 10mm tall. You will receive 2 units (because we all make mistakes) but only install one and only install on the left side.

Be sure the edge is aligned even with the blue line and the bottom of the guide should be even with the blue line.

If you do need to remove, use isopropyl alcohol and dental floss under the unit to loosen the tape.